KEY TO ANALYTICAL RESULTS REPORT

SAMPLE STATION INFORMATION
STATION_ID: Statewide site identifier Code
STATION: Agency identifier code
LATITUDE: Latitude expressed in degrees, minutes, and seconds
LONGITUDE: Longitude expressed in degrees, minutes, and seconds
COUNTY: Name of county from which sample is taken
WATERBODY: Name of surface waterbody or aquifer from which water is withdrawn
CASE DEPTH: Total depth to bottom of well casing from land surface (well only)
TOTAL DEPTH: Total depth of well (well only)
CASING MATERIAL: Descriptive code of casing material (well only)
  A = ABS plastic				O = Other plastics
  B = Brick					P = PVC
  C = Concrete					R = Rock or stone
  D = Copper or copper alloy			S = Steel
  F = Fiberglass				T = Tile
  G = Galvanized iron or steel			U = Unknown
  I = Wrought iron				W = Wood
  L = Black iron or black steel			V = Glued PVC
  M = Other metals				X = Unglued PVC
  N = Stainless Steel				Y = No Casing
  Z = Other materials
CASING DIAMETER: Diameter of well casing in inches

ANALYTICAL DATA INFORMATION
SAMPLE DATE: Date sample was collected (yyyymmdd)
SAMPLE TIME: Time sample was collected (hhmm)
PARAMETER NAME: Proper name of chemical constituent or measurement
VALUE: Measured amount of constituent in sample or measurement result
VALUE QUALIFIER: Code(s) describing characteristics of value 
  A = Average value
  F = The reported value failed to meet field quality control criteria
  I = The reported value is between the method detection limit and the practical quantitation limit
  J = The reported value failed to meet laboratory quality control criteria
  K = The actual value is less than the value given
  N = Component tentatively identified
  O = Sampled but analysis not performed
  Q = Sample held beyond the accepted holding time
  T = Value reported is less than the method detection limit
  U = Compound was analyzed for but not detected
  V = Analyte was detected in quality control blank samples at similar concentrations
  W = Aspects of the well construction may significantly influence the representativeness of the value
  ! = Reported value is outside the range established for the given area
  ? = Reported value is outside the range established for the given site
UNITS: Measurement units


